REMOVAL OF THE OLD STOCK

 

Before any disassembly of the gun, MAKE SURE IT IS UNLOADED.

Point the RIFLE in a safe direction to unload it.

 Remove the magazine, clear the action and check barrel and chamber to ensure they are clear of any rounds.

​

Remove Existing STOCK as per the instructions of the manufacturer. Be careful not to damage the existing STOCK.

Set aside and preserve the factory STOCK, 

 

 

 

Installing THE New STOCK

 

Clean the BUFFER TUBE before installing new STOCK.

THEN SLIDE THE SUPPLIED O-RING OVER THE BUFFER TUBE ALL THE WAY TO THE SHOULDER THIS IS TO HELP ABSORB SHOCK TO THE STOCK AND TAKE UP ANY PLAY TO ELIMINATE MOVEMENT AND IS A VERY IMPORTANT DESIGN FEATURE.

THEN USE THE SUPPLIED SCREW OR THE O.E.M SCREW AND TIGHTEN IT DOWN SNUG. DO NOT OVERTIGHTEN. 

TIGHTEN JUST ENOUGH TO BOTTOM OUT ON THE REAR OF THE BUFFER TUBE THE O-RING WILL CRUSH DOWN AND DO ITS JOB.

If you're not sure, ASK US!  We have installed STOCKS ourselves and are familiar with the process.  Don't wait until the problem is insurmountable, or damage is done to the gun or STOCK.  USE THE SUPPLIED SCREW AND WRENCH OR USE THE EXSISTING HARDWARE IF AVAILABLE.